Mason Chimney Repair · Pinellas County, FL

Chimney Flashing Repair in Pinellas County, FL

Flashing is the metal that seals the joint where your chimney meets the roof — and it’s the single most common source of chimney leaks. When it rusts, lifts or was installed wrong, water runs into your attic, ceiling and walls. We repair or replace flashing with proper step and counter-flashing, not just a bead of sealant.

Licensed & insured · Same-week service · Serving all of Pinellas County.

Chimney flashing repair at a glance

BEST FOR

Ceiling or wall stains near the chimney, attic leaks, rusted or lifted flashing, and leaks after a re-roof.

WHAT WE DO

Inspect the roofline, repair or replace step and counter-flashing, and seal it correctly.

SERVICE AREA

All of Pinellas County and the Gulf beaches.

WHY CHOOSE US

We fix flashing the right way — with metal, not just caulk — and check the rest of the chimney too.

FLASHING SERVICES

Flashing repair & replacement

Proper chimney flashing has several parts that work together. When one fails, water gets in.

Step flashing

Overlapping metal pieces woven into the roofing along the sides of the chimney.

Counter-flashing

Metal set into the masonry that covers the step flashing and sheds water.

Cricket installation

A small peaked roof behind wide chimneys that diverts water around them.

Re-roof tie-ins

Correcting flashing that was reused or poorly installed during a new roof.

Prefab chase flashing

Sealing where a framed chimney chase meets the roof.

Sealant & resealing

Proper sealants where needed — as part of a metal flashing system.

Mortar joint repair

Repointing the joints where counter-flashing is set.

Leak diagnosis

Confirming flashing is the source before we repair it.

DIAGNOSE IT RIGHT

Not sure if it's the fireplace or the chimney?

Many homeowners call about one obvious symptom — water inside, a smoky room, rust, odor, or a gas unit that won’t stay on. The real failure is often higher up. We start with the symptom and find the source before we quote for a repair .

FIREPLACE SIDE · WHAT YOU SEE

Everything inside the room

The part you see and use every day.

Chimney Leak Repair Flashing Seminole

CHIMNEY SIDE · WHERE IT STARTS

Everything above the roofline

Where the problem usually begins.

WHY FLASHING FAILS

Why chimney flashing leaks in Florida

Flashing takes the full force of Florida storms. Wind-driven rain, heat and salt air break it down, and re-roofing often makes it worse.

Chimney Inspection Seminole Report

RE-ROOFING

New roof, old flashing

Roofers sometimes reuse old flashing or skip counter-flashing and rely on caulk. These leaks often start soon after a new roof.

RUST

Salt air corrosion

Galvanized and steel flashing rusts near the coast, opening holes and gaps.

WIND

Storm damage

High winds can lift or bend flashing, especially on exposed coastal homes.

MOVEMENT

Sealant failure

Heat makes the roof and chimney expand and contract at different rates, breaking sealant-only joints.

SIGNS

Signs your flashing is failing

Flashing leaks usually show up inside before you can see a problem on the roof.

Firebox Panel Repair Seminole

COST FACTORS

What chimney flashing repair costs in Pinellas County

Every home is different, so we give a written price after we see the actual problem – no phone quotes pulled from thin air. Here’s what moves the number up or down.

Repair vs. replace

Resealing or repairing a section costs less than full replacement.

Chimney width

Wider chimneys need more flashing and sometimes a cricket.

Roof type

Shingle, tile and metal roofs need different flashing methods.

Roof pitch & height

Steep or tall roofs take longer to work on safely.

Masonry condition

Counter-flashing may require repointing the mortar joints.

Materials

Coastal-rated metals cost more but resist rust much longer.

The most reliable way to get an accurate number is a same-day inspection: we show you what’s happening, explain what’s urgent and what isn’t, and give you an upfront written price before any work starts.

HOW IT WORKS

A clear process, start to finish

No guessing, no scare tactics. We show you what’s happening and explain what actually needs to be fixed.

Identify the system

Masonry, prefab, wood, gas, direct vent, ventless, insert or log set — we confirm exactly what you have.

Inspect the fireplace

Firebox, panels, damper, rust, water signs, smoke marks, odor and flame behavior.

Check the chimney

Cap, crown, chase cover, flashing, liner, draft and every water-entry point above the room.

Diagnose the cause

We explain what's failing, why it's happening, and which part is driving the symptom.

Repair the failure point

Damper, firebox, gas unit, cap, chase cover, leak, draft, masonry or prefab — fixed properly

Confirm it works

Better draft, less moisture, no odor, and a system that makes sense again.

WHERE WE WORK

Chimney flashing repair across Pinellas County

Our crews work every part of Pinellas County every week — from Tarpon Springs, East Lake and Palm Harbor in the north, through Dunedin, Clearwater, Safety Harbor, Largo and Seminole, down to St. Petersburg, Gulfport and the Gulf beaches from Indian Rocks to Pass-a-Grille.

Chimney Cap Crown Repair Pinellas

WHY HOMEOWNERS TRUST US

Local, insured, and accountable for the fix

15+ yrs

Coastal chimney & fireplace experience

Licensed

Fully insured in Florida

Same day

Inspections & 24/7 emergencies

Upfront

Written diagnosis & price, no surprises

Workmanship guarantee

We stand behind our repairs. If a fix we made doesn't hold, we come back and make it right.

Service areas

Serving all of Pinellas County & the Gulf beaches

Local crews based in St. Petersburg, Seminole, Clearwater and Palm Harbor cover the whole county — mainland neighborhoods, waterfront homes and the barrier islands.

MAIN ROUTES WE RUN DAILY

CHIMNEY FLASHING REPAIR FAQ

Answers before you call

Flashing is the metal that seals the joint between the chimney and the roof. Proper flashing has two layers — step flashing in the roofing and counter-flashing set into the chimney.

Small sections can sometimes be repaired, but rusted, lifted or improperly installed flashing usually needs replacement to stop leaks for good.

Flashing problems are common after re-roofing, especially if old flashing was reused or counter-flashing was skipped. We inspect and correct the tie-in.

No. Caulk can supplement metal flashing, but on its own it cracks and fails in Florida heat.

Yes. We can coordinate with your roofer, especially during a re-roof, so the chimney is flashed correctly.

It depends on the chimney size, roof type and whether repair or replacement is needed. We give an upfront written price before any work starts.

FREE ESTIMATE REQUEST

Request chimney flashing repair

Tell us what you are seeing and where you are in Pinellas County — we will call you back to schedule.





    PINELLAS COUNTY · OPEN 24/7

    Get your chimney checked before it gets worse

    Water after rain, odor in humidity, smoke in the room, or a gas fireplace acting up —
    we find the cause, explain it clearly, and fix the right thing.

    Quick Links
    Social
    Operating hours
    Reach Us

    Copyright © 2026 Mason Chimney Repair St Pete | All Right Reserved.